Product appearance
Appearance

R240D

R230D
Interfaces

R240D
1. ETH0 to 3: 10M/100M port used to connect to the wired Ethernet
2. Phone: phone interface connects to a POTS phone or modem device
3. GE/PoE: 10M/100M/1,000M port used to connect to the wired Ethernet. The port can connect to a PoE power supply to provide power for RUs
4. Phone: phone interface connects to a traditional PSTN
5. Default: reset button used to restore factory settings if you hold down the button for more than 3 seconds
6. Power input interface: 12V DC

R230D
1. ETH/PoE: 10/100M port used to connect to the wired Ethernet. The port can connect to a PoE power supply to provide power for RUs
2. Default: reset button used to restore factory settings if you hold down the button for more than 3 seconds
LED indicators
Type |
Color |
Status |
Description |
Default Status after Power-on |
Green |
Steady on |
The AP is just powered on and the software is not started yet. |
Software Startup Status |
Green |
Steady on after blinking once |
After the system is reset and starts uploading the software, the indicator blinks green once. Until the software is uploaded and started, the indicator remains steady green. |
Running Status |
Green |
Blinking once every 2s (0.5 Hz) |
The system is running properly, the Ethernet connection is normal, and STAs are associated with the AP.
The system enters the Uboot CLI.
|
Blinking once every 5s (0.2 Hz) |
The system is running properly, the Ethernet connection is normal, and STAs are associated with the AP. |
Alarm |
Green |
Blinking once Alarm Green every 0.25s (4 Hz) |
The software is being upgraded.
After the software is uploaded and started, the AP working in Fit AP mode requests to go online on the AC and maintains this state until it goes online successfully on the AC (before the CAPWAP link is established).
The AP registration fails (the CAPWAP link is disconnected).
|
Fault |
Red |
Steady on |
A fault that affects services has occurred, such as a DRAM detection failure or system software loading failure. The fault cannot be automatically rectified and must be rectified manually. |
Networking and applications
As shown in the figure, the downlink GE interfaces of the central AP support PoE power supply and can be directly connected to RUs. The central AP can connect to more RUs through a PoE switch. RUs are deployed indoors and communicate with the central AP through network cables.
